Planning wattage range
50-150 W. Use a measured average when the device matters.
Menu
Electric blanket Runtime Estimate
Electric blankets cycle by heat setting. Lower settings can reduce average draw.
Planning default
100 W at 50% duty cycle, or about 50 W average load.
Confidence label
Estimated. Treat the result as a planning estimate, not a lab measurement.
1,024 Wh example
With 85% efficiency and a 10% reserve, about 783 Wh remains usable. At the default load, that is roughly 15h 40m.
Evidence behind these load values
Published device values and editorial calculator assumptions have different evidence. An editorial range is a starting input, not a measured category range; replace it with your device reading. Context links explain units or compatibility and do not prove the numbers. The check date records the evidence classification, not a new hardware test.
Swipe table sideways
| Value | Evidence type | Conditions | Source and dates | Confidence |
|---|---|---|---|---|
| Planning wattage range50-150 W | Source-reported range |
| estimated | |
| Planning default100 W | Editorial planning default |
| No separately attributed sourceSource date: UnknownChecked: | estimated |
| Duty cycle50% | Editorial planning default |
| No separately attributed sourceSource date: UnknownChecked: | estimated |
Device measurement guide
Use the measured average
Enter a steady watt reading or a full-cycle average in the runtime calculator. Use 100% duty cycle for an average that already includes on and off periods.
- Device wattage (W)
- Read watts after a steady load settles; record energy over time for a cycling load.
- Duty cycle (%)
- Average watts calculated from Wh divided by hours already include off-cycle time, so do not apply duty cycle again.
Verify your watts
- Check the device label for running watts or input amps and volts.
- Use a plug-in watt meter for AC loads when the result matters.
- For cycling loads, measure long enough to capture on/off behavior.
Check output path
- AC inverter loads usually lose more energy than direct DC loads.
- Keep reserve for cold weather, battery age, and load changes.
- Do not treat label capacity as fully usable watt-hours.
How to use this scenario
- Start with 100 W if you do not have a watt-meter reading yet.
- Electric blanket is treated as a cycling load at 50% duty cycle, so the calculator averages the running watts over time.
- Keep at least a planning reserve because battery age, temperature, output path, and device settings can move the result.
Watch-outs
- The scenario wattage is an estimate. Measure the real load before relying on it for outage, travel, or critical planning.
- Cycling devices can run longer or shorter depending on ambient temperature, thermostat settings, insulation, and door openings.
Sources
- Renogy electric blanket wattage guide (editorial) - Reports a broad 50-150 W electric-blanket range by size and heat setting. The 100 W calculator default and 50% duty cycle are separate editorial planning assumptions, not measured values from this guide.
- U.S. Department of Energy power and energy definitions (official) - Defines watts, volts, amps, and kilowatt-hours for the site's unit conversions; it is methodological context, not a source for individual appliance wattage ranges.
Use this load in the runtime calculatorCheck source wattage rangesFind a practical power station sizeCompare runtime by battery capacity
Related Scenarios
Compare nearby loads before assuming one wattage profile covers your setup.
Portable fan
20-75 W, default 35 W, confidence: Estimated.